Difference between revisions of "Cheese making/Experiment 3"

From Real Vegan Cheese
Jump to navigation Jump to search
Line 24: Line 24:
Materials
Materials
Micellar casein powder: "BodyTech 100% micellar casein."
Micellar casein powder: "BodyTech 100% micellar casein."
Ghee:


Salts:
Research into milk composition indicated this relative composition:
Research into milk composition indicated this relative composition:
protein:
protein:
Line 37: Line 37:
magnesium:
magnesium:


Methods


Procedure for re-assembly of milk


Milk was re-assembled by heating 500mL of distilled water in an Erlenmeyer flask on a heated stir plate
'''Re-milk creation'''
 
500mL of distilled water in an Erlenmeyer flask was warmed to 37.5 C on a heated stir plate.
The heated stir plate was set to a mixing speed of approximately "0.8", and a temperature setting of around 85, though, the temperature was occasionally varied to achieve a solution temperature between 35 and 38 C (as measured by the Cen-Tech infared thermometer on the part of the liquid surface not covered by liquid ghee.)
Citrate was initially added to a achieve a final citrate concentration of 8.47 mM.
Casein powder was added to the 500mL water at a rate of 2-5 grams once every 15min, with the full weight of 18.8 g casein ultimately added over 45 minutes.
Ghee was added at a rate of 2-5g every 15 minutes, ultimately adding 20.22g over 45 minutes.
Lactose was added at a rate of 10-2g every 15 minutes, ultimately adding 24g over 45 minutes. (note: lactose occasionally caused the stir plate motor to stall, requiring the heated stir plate to be re-started)
The lactose, ghee and casein were added in a staggered fashion, such that the powdered casein or lactose did not land on a big chunk of solid ghee.
 
After all ingredients were added the pH of the mixture was found to be approximately 6.8 (using a swimming pool test kit which employed a phenol red indicator and a set of liquid standards. 7µL of phenol red indicator was added to 1 ml of the re-milk mixture.) pH was adjusted to 7.7 by adding two 1mL portions of a saturated (500mM) tri-sodium phosphate (TSP) solution.
 
This mixture was placed in a fridge over night at approximately 1 degree C. Upon removing from the fridge, a solid layer of ghee was found at the top of the liquid, but no solid precipitate could be found.
The mixture was reheated first in a warm water bath, then on the heated stir plate (speed = 1, temp = 85) until the temperature at the liquid surface was measured at approximately 35 C.
 
'''Sonication'''
The re-heated re-milk mixture was shaken to attempt to distribute the oil layer, then approximately 125 mL of the re-milk was poured into a cut off (to ~ 3") dixie cup and placed in a the sonicator. Warm water was added to the sonicator bath to bring it to the same level as the re-milk in the dixie cup.
The sonicator was then run for 32 minutes. The sonication did cause heating of the water, and at 24 minutes the water bath temperature was found to be 42 C; cool water was added to bring the temperature down to 34 C.
 
'''Results of milk re-assembly'''
 
Initial mixture of ingredients produced a translucent yellowish solution with a layer of
 
Sonication made a significant change in the re-milk's appearance, giving it a nice opaque white, much more milk-like quality. It is difficult to tell if the sonication had a significant lasting or permanent effect on the amount of liquid ghee in a stable emulsion -- persisting not in the non-polar layer on the top, but in solution with the re-milk/lactose layer on the botton. Comparing the photographs at 15 and 32 minutes, it appears the sonication at least transiently drove some of the oil layer into solution.




Line 59: Line 81:




 
{| class="wikitable"
|-
! HeaderR0C1 !! HeaderR0C2 !! HeaderR0C3
|-
| ExampleR1C1 || ExampleR1C2 || ExampleR1C3
|-
| ExampleR2C1 || ExampleR2C2 || ExampleR2C3
|-
| ExampleR3C1 || ExampleR3C2 || ExampleR3C3
|}


'''Discussion'''
'''Discussion'''
----
----

Revision as of 22:00, 11 March 2015

Goal


Test production of cheese from re-assembled milk. Re-assembled milk is to be made from

  • micellar casein powder
  • lactose
  • salts
  • ghee

Background


Production of cheese requires fats, sugars and salts as well as the casein protein. Our molecular biology team is currently developing a yeast-based casein production platform, but to achieve a product that is completely vegan the sugars and fats must come from non-animal sources as well. The goal of this series of experiments is to test the use of alternate sugars for the cheese ripening process.

The purpose of Experiment 3 in particular is to test an initial positive control: production of cheese from re-assembled milk. This re-assembled milk is produced by combining micellar casein powder, lactose, ghee and a mixture of salts. This expands on the casein solubilization techniques developed in Experiment 2, adding sugars, oils and salts, then ultimately producing cheese from the re-assembled milk.

Methods and results


Materials Micellar casein powder: "BodyTech 100% micellar casein." Ghee:

Research into milk composition indicated this relative composition: protein: fat: lactose sugar:

salts citrate: calcium: phosphate: magnesium:


Re-milk creation

500mL of distilled water in an Erlenmeyer flask was warmed to 37.5 C on a heated stir plate. The heated stir plate was set to a mixing speed of approximately "0.8", and a temperature setting of around 85, though, the temperature was occasionally varied to achieve a solution temperature between 35 and 38 C (as measured by the Cen-Tech infared thermometer on the part of the liquid surface not covered by liquid ghee.) Citrate was initially added to a achieve a final citrate concentration of 8.47 mM. Casein powder was added to the 500mL water at a rate of 2-5 grams once every 15min, with the full weight of 18.8 g casein ultimately added over 45 minutes. Ghee was added at a rate of 2-5g every 15 minutes, ultimately adding 20.22g over 45 minutes. Lactose was added at a rate of 10-2g every 15 minutes, ultimately adding 24g over 45 minutes. (note: lactose occasionally caused the stir plate motor to stall, requiring the heated stir plate to be re-started) The lactose, ghee and casein were added in a staggered fashion, such that the powdered casein or lactose did not land on a big chunk of solid ghee.

After all ingredients were added the pH of the mixture was found to be approximately 6.8 (using a swimming pool test kit which employed a phenol red indicator and a set of liquid standards. 7µL of phenol red indicator was added to 1 ml of the re-milk mixture.) pH was adjusted to 7.7 by adding two 1mL portions of a saturated (500mM) tri-sodium phosphate (TSP) solution.

This mixture was placed in a fridge over night at approximately 1 degree C. Upon removing from the fridge, a solid layer of ghee was found at the top of the liquid, but no solid precipitate could be found. The mixture was reheated first in a warm water bath, then on the heated stir plate (speed = 1, temp = 85) until the temperature at the liquid surface was measured at approximately 35 C.

Sonication The re-heated re-milk mixture was shaken to attempt to distribute the oil layer, then approximately 125 mL of the re-milk was poured into a cut off (to ~ 3") dixie cup and placed in a the sonicator. Warm water was added to the sonicator bath to bring it to the same level as the re-milk in the dixie cup. The sonicator was then run for 32 minutes. The sonication did cause heating of the water, and at 24 minutes the water bath temperature was found to be 42 C; cool water was added to bring the temperature down to 34 C.

Results of milk re-assembly

Initial mixture of ingredients produced a translucent yellowish solution with a layer of

Sonication made a significant change in the re-milk's appearance, giving it a nice opaque white, much more milk-like quality. It is difficult to tell if the sonication had a significant lasting or permanent effect on the amount of liquid ghee in a stable emulsion -- persisting not in the non-polar layer on the top, but in solution with the re-milk/lactose layer on the botton. Comparing the photographs at 15 and 32 minutes, it appears the sonication at least transiently drove some of the oil layer into solution.


After addition of all ingredients

Re-assembled milk on heated stir plate, pre sonication
How the sonicator was set up plus the settings on the heated stir plate.
Re-assembled milk immediately before sonication
Re-assembled milk, after about 15 minutes of sonication
Re-assembled milk, after 32 minutes of sonication
Comparison of re-assembled milk before (right) and after (left) sonication.

The cheese making recipe used here attempts to replicate the instructions found a the ["Gouda, A Cheese from the North Country"] page of the cheesemaking.com website.


HeaderR0C1 HeaderR0C2 HeaderR0C3
ExampleR1C1 ExampleR1C2 ExampleR1C3
ExampleR2C1 ExampleR2C2 ExampleR2C3
ExampleR3C1 ExampleR3C2 ExampleR3C3

Discussion