Plating URA- and turbo Yeast Control

From Real Vegan Cheese
Revision as of 02:42, 15 June 2016 by Ben Rupert (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

May 9th 2016

(recorded by Ben)

-Yeast (URA-, any further name?) from the liquid culture that Marc had left overnight in the 30 C incubator

-Turbo yeast, several grains added to water (20 mL) with about 3x the yeast's volume in sucrose

-The plates, except Teknova, were poured by CCL and were uneven. We microwaved the plates to melt them, ending up going about 1.5 minutes in 10 second intervals.

-100 uL of each yeast solution streaked onto each of four plates:

 1. YPD
 2. SD -URA +Glu
 3. YPD +5FOA
 4. Teknova YPD + Uridine

-plates placed in 30 C incubator.

YeastPlatesURA-Turbo.png

May 10th 2016

(notes from Patrik)

We're getting abundant growth on all plates for both yeast strains, except for the defined medium without URA, on which neither strain seemed to grow. :-(

Problems:

1) Lots of growth with turbo yeast on the 5-FOA plate, which should not happen. Either turbo yeast is weird and doesn't get killed by 5-FOA (so we should get a lab yeast strain as control instead), or the 5-FOA was inactive or too low concentration.

2) No growth of turbo yeast on the defined medium plate. We should check the defined medium plates again, in case it just takes longer for the turbo yeast colonies to grow on that one. Can't really see it on the photographs, but there were definitely some faint traces of where I streaked the plates - could just be dried broth, or a haze of microcolonies. Either way, the plates look exactly the same for the turbo yeast and our supposedly URA- yeast.

The defined medium we made were defined much lower concentration than the YPD plates (as you can kinda tell from the much lighter color of the plates). Standard YPD is 50 g/L, but for the defined medium we only used something like 8g/L?

I also screwed up weighing out the YPD when we made the media. Luckily Marc caught it and I think we were able to correct it. That doesn't explain why the turbo yeast and the supposedly URA- yeast behave exactly the same. But it's probably still worth redoing these plates again to be sure.

YPD TurboYeast.png SD-URA+glu TurboYeast.png TeknovaYPD+uridine TurboYeast.png YPD+5-FOA TurboYeast.png

YPD Yeast-URA.png SD-URA+Glu Yeast-URA.png Teknova YPD+uridine Yeast-URA.png YPD+5-FOA Yeast-URA.png

Next steps:

- Get a lab yeast strain that we know is sensitive to 5-FOA - Verify concentration of 5-FOA and defined medium to use - Pour some more YPD, YPD+5-FOA and SD-URA plates - Restreak with URA- and 5-FOA sensitive yeast strains